Page 1 of 1

Gibb winches maintenance

Posted: Sun Sep 16, 2018 4:04 pm
by bubulo
Hello

I have recently purchased a fin keel Sabre 27 and would like to know if anyone had the experience of doing the maintenance of the Gibb winches with a fixed handle on the bottom?

The winches on my boat are a bit stiff and presumably they need cleaning and lubricating.

If anyone had the experience of doing this and perhaps have some photos showing the process that will be very much appreciated.

I am concerned of losing parts of these discontinued winches when dismantling them.

Many thanks

Alex

Re: Gibb winches maintenance

Posted: Sun Sep 16, 2018 4:56 pm
by samphire2014
Search for service Gibb winches on Google. Follow link to westerley centaur winches. Click Serviced winches, go to 8th thread down and there is a link to a how too page with pictures and instructions. If you are short of a cleaner, diesel does a good job of dissolving old grease.

Re: Gibb winches maintenance

Posted: Sun Sep 16, 2018 5:38 pm
by bubulo
Great!

Many thanks for your help

I will try it!

Alex

Re: Gibb winches maintenance

Posted: Sun Sep 16, 2018 9:04 pm
by samphire2014
I did it from iPad and I am no expert. If you struggle to find it, I will run it on my laptop and mail you the proper link.
Best
Chris

Re: Gibb winches maintenance

Posted: Mon Sep 17, 2018 8:03 pm
by bubulo
Hi Chris

If you could email me the link will appreciate it

Many thanks

Alex

Re: Gibb winches maintenance

Posted: Tue Sep 18, 2018 9:34 am
by samphire2014

Re: Gibb winches maintenance

Posted: Tue Sep 18, 2018 9:17 pm
by bubulo
OK Chris many thanks

I will try it!

Alex

Re: Gibb winches maintenance

Posted: Wed Sep 19, 2018 8:26 pm
by bubulo
Chris

Tried to remove the winch covers today but no luck. They are really hard to remove. I must be doing something wrong. Do you know of any other site with more instructions/photos on how to clean the Gibb winches? Many thanks
Alex

Re: Gibb winches maintenance

Posted: Thu Sep 20, 2018 8:51 am
by samphire2014
Hi, I am not an expert, but have done the research as I faced the same problem when I first bought my boat. I have lewmar winches, but they were stuck on as well, so you have my sympathy!

http://www.ybw.com/forums/showthread.ph ... ch-removal

According to this http://www.bluemoment.com/manuals/gibbwinches.pdf should lift off after removing retaining screw. The split bearing may have something (broken spring part?) in the groove making it tight for removal.
Read more at http://www.ybw.com/forums/showthread.ph ... Gtq4xDW.99

You just have to keep turning and lifting up at the same time. Gentle warming with a hot air gun may help soften the grease inside. Be careful about using too much heat as the plastic sleeves can be damaged and replacements are obtainable. If you're just softening grease, a hot air gun or hair dryer is safer.

Read more at http://www.ybw.com/forums/showthread.ph ... Gtq4xDW.99
Read more at http://www.ybw.com/forums/showthread.ph ... Gtq4xDW.99
(Borrow wife's hair drier?)

https://www.youtube.com/watch?v=GJEM_U3WMEo - This will show you what to expect once you get the drum off.

Hope this helps.

Good luck

Chris

Re: Gibb winches maintenance

Posted: Thu Sep 20, 2018 7:43 pm
by bubulo
Many thanks again Chris

I managed to take off the covers!

All done

Quite easy really....once you know how to do it!

Thanks again

Alex