Hello,
I am restoring Tillew in Galway. Ithad been neglected over the last few years. And needs a lot of tidying up and.The ply flooring in the Cabin is broken with a large piece missing. I need to make up a new one but was wondering if was originally in more than one piece and if anyone had pictures/drawings of theirs.
Any help appreciated
Best Regards,
Tom Byrne
Floorboards on Sabre 27
-
- Posts: 66
- Joined: Tue Jul 18, 2017 12:47 pm
Re: Floorboards on Sabre 27
Sadly, you have not told us if your boat is a Mk1 or Mk2?
There is a PDF showing the fit out plans for a Mark 2 in the archive, but whilst the floorboard profiles are shown, none have any dimensions. if yours is a Mark 2, I can photograph mine and take some dimensions the next time I am there (although, with the Mk2 it should be obvious and just a case of tracing around the rebated recess)
There is a PDF showing the fit out plans for a Mark 2 in the archive, but whilst the floorboard profiles are shown, none have any dimensions. if yours is a Mark 2, I can photograph mine and take some dimensions the next time I am there (although, with the Mk2 it should be obvious and just a case of tracing around the rebated recess)
Re: Floorboards on Sabre 27
I have photographed mine, which is a dinette version.The main section is a parallel sided piede and there is a shaped section to either side, with a removable piece above the bilge pump. You can see that the full length cosmetic board is loose and can be removed , allowing the section above the bilge pump to then be removed if the central piece is lifted. There are holes to locate the bottom of the companionway steps.
Yes, it's all filthy, but will be getting cleaned soon!
Yes, it's all filthy, but will be getting cleaned soon!
- Attachments
-
- 2021-07-31 18.25.49.jpg (2.21 MiB) Viewed 12757 times
Jerry Jones
Sea Spear
Weston-super-Mare
Sea Spear
Weston-super-Mare
-
- Posts: 6
- Joined: Wed Jul 28, 2021 9:26 pm
Re: Floorboards on Sabre 27
Thank you Jezzs
I'm.not sure whether mine is Mk 1 or 2.
There is a recess under the galley area at one side.
I was going to use ply wood but yours appear to be a number of separate boards. Which would make life easier. What are they made from?
Where have you located your bilge pump?
Thanks again
Tom
Galwaycub@gmail.com
I'm.not sure whether mine is Mk 1 or 2.
There is a recess under the galley area at one side.
I was going to use ply wood but yours appear to be a number of separate boards. Which would make life easier. What are they made from?
Where have you located your bilge pump?
Thanks again
Tom
Galwaycub@gmail.com
Re: Floorboards on Sabre 27
You can see the bilge pump in the photo above.
Jerry Jones
Sea Spear
Weston-super-Mare
Sea Spear
Weston-super-Mare